Bench Motor 250W

250 Watt , 50Hz Supplied with L& R spindle.

Single ON / OFF Switch

* Buffs are not included and shown for demonstration purposes only *

Polishing and Buffing Wheels in Action

When brushes, buffs or wheels turn at high RPM on a polishing lathe, tremendous centrifugal forces cause walls to flatten and compact.

The walls of the wheel or buff flatten and become stiff and under the circumstances the face surface becomes uniform creating a flat plane to the contacting metal.

This force, as much as the wheel material and the abrasive applied gives the wheel its working qualities and produces the result.

When the wheel revolves, it turns toward the worker and exerts a downward pressure. It is important to bring the metal at a tangential angle then into sideways motion contact with the revolving wheel and only in the area of buffs forward lower quarter segment.

If the work is applied at any other section of the turning buff wheel the work will be torn from your hands by the opposing direction of the turning wheel. Injury or damage to work piece can be a consequence.

The problem of frictional heat is caused because two forces are at play. Pressure and RPM. Greater pressure or higher RPM imply increasing heat. Metal is a good heat conductor.

Excessive pressure removes too much metal to be worn away = monetary loss. Your binder or abrasive will also burn a glaze onto the buff spoiling it permanently.

Solutions include wearing rubber finger cots or leather cots to insulate. Minimise heat build up with short passes or intervals to allow brief cooling.

Wood ring clamp can hold work, wood is a poor conductor of heat compared to metal.

We have a large selection of bristle brushes , cloths , mops & polishing machines too! Extractor units also available.

WARNING! 

When using mechanical equipment always ensure loose clothing is confined. Long hair must never hang loose, tie your hair back.

Remove any articles on you that may catch in any way or protrude from your person.

Some profiles of jewelry can be supported using a flat piece of wood, wrap chains around a flat stick, polishing only a short piece at a time. Do so positioning the chain parallel to the direction of the wheel.

Stop use if the wheel/buff is unstable or chattering or unbalanced. The wheel face should always appear crisp if it blurs it is not running true.

If the piece becomes tangled in the moving equipment do not try and rescue it, withdraw hands and switch off.